Turning The Unit On/Off - Furuno COLOR VIDEO PLOTTER 1833C Operator's Manual

1. OPERATIONAL OVERVIEW
1.3

Turning the Unit On/Off

Press the [POWER/BRILL] key to turn the unit on. A beep sounds and the
equipment proceeds in the sequence shown below, displaying product
information, startup test results and the chart usage disclaimer. The startup test
checks the ROM, RAM, internal battery and backup data for proper operation,
displaying the results for each as OK or NG (No Good). If NG appears an
appropriate message appears on the screen. For any NG, try to press any key to
go to the chart disclaimer screen, then perform the diagnostic test as shown in
the paragraph "7.6 Diagnostics."
Chart List
Host Name
*
RADAR PLOTTER
STATION NAME:
RADAR#
FURUNO ELECTRIC CO., LTD.
CHARTS AVAILABLE
LICENSE NO.
For start up with the radar display, the magnetron takes from one minute to
two minutes and thirty seconds (depending or radar model) to warm up before
the radar can be operated. The time remaining for warm up of the magnetron is
counted down at the center of the display.
You may press any key at the chart disclaimer screen to show the last-used
display, or wait several seconds to let the equipment do it for you.
To turn the unit off, press and hold down the [POWER/BRILL] key until the
screen goes dark (approx. 3 sec.). To protect the LCD attach the hard cover.
Note that the network sounder will be turned off approx. three minutes after
turning off the power.
Note: The first time you turn on the power (or any time the power is applied after
a memory reset), you are asked if you want to start the simulation mode,
which provides simulated operation of the equipment. Push the [ENTER]
knob to start the simulation mode, or press the [CLEAR] key to start
normal operation. For further details about the simulation mode, see the
paragraph "1.10 Simulation Display."
1-6
* = "GD-1900C Plotter" for GD-1900C
#= Name determined at installation.
STARTUP TEST
ROM
RAM
è
INTERNAL BATTERY
BACKUP DATA
Startup sequence
** = Program version no. for
FURUNO/NAVIONICS
model. 19500010XX for C-MAP model.
XX = program version no.
NO NATIONAL HYDROGRAPHIC
OFFICE HAS VERIFIED THE
INFORMATION IN THIS
OK
COASTLINE DATA CARD AND NONE
OK
ACCEPT LIABILITY FOR THE
è
ACCURACY OF REPRODUCTION OR
OK
ANY MODIFICATIONS MADE
OK
THEREAFTER. THIS PRODUCT WITH
THIS COASTLINE DATA CARD
DOES NOT REPLACE THE
REQUIREMENT TO USE THE
APPROPRIATE PRODUCTS FOR
NAVIGATION ACCORDING TO
NATIONAL AND INTERNATIONAL
REGULATIONS.
PROGRAM No. 19500020XX**