Configuring Memory Board Function Jumpers - NEC HV8600 User Manual

Switch Description
SW1 Dump/Reset
pushbutton
control
SW2 Dump/Reset
pushbutton
mode control
SW3 Reserved for
future use.
SW4 Reserved for
future use.

Configuring Memory Board Function Jumpers

The system memory board jumpers enable you to specify the DIMM speed
parameter. Figure 3-3 shows the location of the jumpers. The jumpers should be
configured for 50ns (default setting) as shown in Figure 3-2.
P02
P04
P14
P16
Table 3-4. Function Select Switch Settings
Settings
Off (factory setting)
On
Off (factory setting)
On
Off (factory setting)
On
Off (factory setting)
On
A
B
C
D
Figure 3-2. Memory Board Jumpers
Function
Enables the Reset/dump button.
Disables the Reset/dump button.
Sets the Reset/dump button to Reset mode.
Pressing the button resets the system.
Sets the Reset/dump button to Dump mode.
Pressing the button dumps the system memory.
This function used only by qualified technical
personnel.
Configuring Your System 3-19
P01
P03
P13
P15
1 2
3
J05
J06
60 50