NEC HV8600 User Manual page 110

6. Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
7. Set any device jumpers or switches on the device. Refer to the installation
procedures that come with the device.
Note:
devices must be installed in the last SCSI device of the daisy
chain cabling (bottom media bay D). All other 5 1/4-inch
devices must have terminators removed.
4-38 Upgrading Your System
Figure 4-29. Removing Blank Panel Tray
Figure 4-30. Removing Side Rails
SCSI termination resistors for the 5 1/4-inch