Installing A Processor Cartridge - NEC HV8600 User Manual

Installing a Processor Cartridge

Use the following procedure to install a processor cartridge.
Note:
cartridge installed in the bottom slot of a CPU backboard
and termination boards in the remaining slots. Some
systems may have more processors, depending on
configuration. All processors must be matched in speed.
1. Power off the system and remove the right side panel as described earlier.
2. Remove the power cable from the CPU backboard (see Figure 4-10).
Figure 4-10. Removing the CPU Backboard Power Cable
3. Remove the two screws securing the terminator board and the CPU
backboard (see Figure 4-11).
Figure 4-11. Removing the Terminator Board
All systems ship with at least a processor
Screws
Terminator
Board
Upgrading Your System 4-19