NEC HV8600 User Manual page 93

S
Open the two card ejectors (one on each side) and pull the card out of the
system (see Figure 4-14).
Figure 4-14. Removing the Termination Card
9. Remove a new processor cartridge from its antistatic package and place it on
a grounded static-free surface or conductive foam pad.
If tabs are not attached to the cartridge, remove them from the termination
card and install on the cartridge.
S
Slightly spread open each tab so that the two pegs on the tab fit into two
holes at the corner of the cartridge. Use care in opening the tab to
prevent breakage.
10. Open the tabs on the cartridge and align the cartridge with the slot so that the
heat sink faces down (see Figure 4-15).
If installing a termination card, align the card so that the embossed logo on
the card faces up.
Upgrading Your System 4-21