Installing Mwa; Creating A Server System Generation Diskette (Sg - NEC HV8600 User Manual

Installing MWA

To use MWA several procedures must be performed to configure the managed
server and the management PC. For ease of installation these procedures should
be performed in the order presented in the following sections. Installation
procedures include procedures to be performed at the server and at the
management PC.
Server Procedures
S
Create a server system generation diskette (SG) containing essential
server networking information.
S
Run the BIOS Setup Utility making the changes to BIOS necessary for
server acceptance of MWA support.
Management PC Procedures
S
Install MWA software on the management PC.
S
Configure and register SG information within MWA at the management
PC.

Creating a Server System Generation Diskette (SG)

For the management PC to connect with a server, server system generation (SG)
information must be configured and registered on MWA software running on
the management PC.
In this procedure you will create a diskette containing your server's SG
information. In the following section, you will register the SG information with
MWA.
1. Prepare a floppy disk, formatted with MS-DOS.
2. Insert the E
server from the CD. The E
3. Select: Custom Setup.
4. Select: System Management.
5. Select: Network Setup. The Network setup program starts.
6. Insert the floppy disk prepared in step 1 into the server's diskette drive and
press the ESC key.
C-4 Management Application Workstation
B CD in the server's CD-ROM drive, and boot the
UILDER
XPRESS
XPRESS
B menu displays.
UILDER