Removing A 5 1/4-Inch Device Or 3 1/2-Inch Diskette Drive - NEC HV8600 User Manual

B
A

Removing a 5 1/4-Inch Device or 3 1/2-Inch Diskette Drive

Remove a 5 1/4-inch device or a 3 1/2-inch diskette drive as follows.
1. Power off the system. Remove the top panel, left front door, and the left side
panel as described earlier in this chapter.
2. Disconnect the signal and power cables from the back of the drive
(see Figure 4-34).
3. Remove the two screws securing the device to the front of the chassis
(see Figure 4-32).
4. Slide the drive out the front of the bay, and place on an antistatic surface.
5. Remove and save the side rails and screws (see Figure 4-31).
6. Place the drive in an antistatic wrapper.
7. Cover an empty bay by installing a blank panel tray in the bay (see
Figure 4-29).
8. Reinstall the top panel, left front door, and the left side panel. Power on the
system.
9. Remove the drive serial number from the equipment log.
C
Figure 4-34. Installing Device Cables
A System I/O board
B Data cable
C Power able
Upgrading Your System 4-41