Complete Reset; Dhw" Menu - Honeywell SDC heating and district heating controller Service Manual

SDC / DHC
Setting
5.2.3.5
5.2.4
EN2H-0221GE51 R0808
ATTENTION
A reset should only be carried out if all individually entered
values are to be replaced by the values specified at the
factory.
► When the PARAM. RESET display flashes, press the input
button î .
SET flashes in the display.
► Press and hold the input button
If a reset is carried out, the RESET OK confirmation appears
briefly. Verification is then started with a call-up of the first
parameter in the respective menu once again.
After the parameter values are reset, a return to the first
parameter in the "System Parameter" menu occurs.

Complete reset

To reset all settings, a complete reset of the device can be carried
out.
A complete reset is initiated when the
are pressed simultaneously until the controller restarts.

"DHW" menu

This menu contains all parameters required to program the hot-
water circuit, except the hot-water switching time programs.
î
for 5 s.
¥ ¦
, , and
Operation
§
keys
77