Honeywell SDC heating and district heating controller Service Manual page 29

SDC / DHC
Cancellation
Factory setting
Setting range
Display
5.1.2.5.2
Setting
Application
EN2H-0221GE51 R0808
An active absence program can be cancelled in case of early
return.
► Press button.
► Turn input button
The active absence program has been cancelled.
P1 as from activation
P1 (P2, P3) / 0.5 to 24 h to the current time
P1 (P2, P3)
Program-controlled resumption of heating operation. After
activation of the absence program, heating operation is
interrupted until the following switch-on time of the current
automatic program P1 (or P2 or P3, if enabled).
0,5 ... 24 h
The set value is added on to the current time and represents the
return time. When the absence program is called up again, the
last set value is saved and suggested as the initial value.
An active absence program appears in the basic display with
information on the return time.
Party mode (short-term program)
Party mode causes one-time intermediate heating of all heating
circuits up to a specified point in time and bridges an upcoming or
already active absence cycle totally or partially. Once the set time
expires, the heating circuits automatically return to the operating
mode that was active before the party program. Short-term
programs such as ABSENT or PARTY are skipped here.
See 5.1.2.5 "Operating mode" button (basic display) , pg. 26
One-time extension of heating operation or intermediate heating
during lowering operation outside the schedule.
î and switch to automatic operation.
Operation
29