Honeywell SDC heating and district heating controller Service Manual page 67

SDC / DHC
NOTE
Select
copy function:
Select
source circuit: Source circuit
Select
source circuit
program:
Select
target circuit:
Select
target circuit
program:
Copy:
Acknowledge:
Exit:
EN2H-0221GE51 R0808
Copying heating circuits
Heating circuits cannot be copied to hot-water circuits since they
have different cycle temperatures: If a heating circuit is selected
as the source circuit, the hot-water circuit can no longer be called
up as the target circuit. The hot-water circuit as the source circuit
is also the target circuit. In this case, only programs of the hot-
water circuit are copied among one another if they were enabled
in the "System Parameter" menu.
HC MC-1
HC
Source circuit
HC P1
Target circuit
HC
Target circuit
MC -2 P1
Copy
-OK-
Basic display
MC-2 DHW
Source circuit Source circuit
MC -1 MC -2
Source circuit Source circuit
MC -1 P2 MC -2
Target circuit Target circuit
MC -1 MC -2
Target circuit Target circuit
MC -2 P2 MC -2
Program P1 (direct heating circuit) =
Program P2 (mixed heating circuit 2)
Copy additional heating circuits
if necessary
Operation
Default Copy
time circuit
1)
P3
1)
P3
67