Table of Contents
Advertisement
SDC / DHC
Logical error
messages
Bus error messages
5.4.1
Para-
Designation
meter
01
Hydraulic
schematic
02
Hot-water charging
pump output
EN2H-0221GE51 R0808
These error messages evaluate the control result to be expected.
They appear depending on the type and allocation with fault code
50 to 60 and index 0, 1 or 2.
These error messages refer to address faults such as double
issuance or non-recognition of address settings on the data bus.
They appear with fault code 70 and index 0 or 1, depending on
the type and assignment.
5.4
Parameter settings
"Hydraulics" menu (HYDRAULIC)
The parameters in this menu refer to the general system
hydraulics and the functions and configuration of the
programmable inputs and outputs for the respective system
components. Representative of many individual settings, the
applications are only defined by the 1st parameter of this setting
table.
Example: The controller is to cover system No 0202. Provided
that the controller features enough relays, parameter 01 must be
set to value 0202.
Setting range / Setting values
0, 0101, 0102, ... n
OFF
1
4
5
No function
Hot-water charging
pump
Circulating pump
Electric heating rod
Operation
Factory
Setting
setting
0
1
81
Advertisement
Table of Contents
