Commands To Set Parameters - AND Weighing Indicator AD-4407 Instruction Manual

Enabling Key Switches Enabling Key Switches Enabling Key Switches Enabling Key Switches
Enables the key switches that are disabled by the DK command. Not applicable to the
keys disabled by f12.
Template
Command
Reply
13.3.3.

Commands to Set Parameters

Set Limit/Setpoint Value Set Limit/Setpoint Value Set Limit/Setpoint Value Set Limit/Setpoint Value
Sets the limit or setpoint value of the comparison. The decimal point is not necessary.
Template
Command
Reply
Set Zero Band Set Zero Band
Set Zero Band Set Zero Band
Sets the f26 value (zero band) of the comparison. The decimal point is not necessary.
Template
Command
Reply
Set Preset Tare Set Preset Tare Set Preset Tare Set Preset Tare
Sets the preset tare value. The decimal point is not necessary.
Template
Command
Reply
Set Unit Weight for Counting Mode Set Unit Weight for Counting Mode
Set Unit Weight for Counting Mode Set Unit Weight for Counting Mode
Sets the unit weight value with decimal point.
Template
Command
Reply
AD-4407 Weighing Indicator
EK,n
n: key switch number (0: all keys, 1 - F: refer F-Function f12)
E K , 0
E K , 0
Sm,n, [ value ]
m: code memory number, 0 - 4
n : setpoint order number, refer to "Setting the setpoint"
S 1 , 3 , + 1 6 0
S 1 , 3 , + 1 6 0
SZ, [ value ]
S Z , + 7 4 8
S Z , + 7 4 8
PT,m, [ value ]
m: code memory number, 0 - 4
P T , 2 , 2 1 3
P T , 2 , 2 1 3
UW,m, [ value ]
m: code memory number, 0 - 4
U W , 2 , 2 1 . 3
U W , 2 , 2 1 . 3
ex. to enable all keys
Page 51
13.3. Command Format