AND Weighing Indicator AD-4407 Instruction Manual page 15

Single Range
Select resolution and decimal point position and format.
Specify the weighing capacity.
Dual Range
<First range> Select the resolution, decimal point position and format.
<First range> Select the weighing range
<Second range> Select the resolution
<Second Range> Specify the weighing capacity
For the range function, refer to "5.3. Weighing Range Function".
Specifying the Range and Unit Specifying the Range and Unit
Specifying the Range and Unit Specifying the Range and Unit
Step 1 The range and unit of measure are displayed.
Range display :
Unit display:
ENTER
ESC
Specifying the Resolution, Decimal Point Position an Specifying the Resolution, Decimal Point Position and Format
Specifying the Resolution, Decimal Point Position an Specifying the Resolution, Decimal Point Position an
Step 2 The resolution will be displayed as d 0. 1 with decimal point. The indicator displays
triangle
the decimal point with the
with the +/- key. Specify the resolution with
is specified in step. The decimal point format for serial data output is selected
using the F-function settings. Press the
the next step. When pressing the
indicator will proceed to the next step without changing them.
AD-4407 Weighing Indicator
5ingl : single range
dUal :
To change the range function, use the
The active unit is displayed. The unit can be changed such as
kg or lb. The calibration is performed with displayed unit.
Press the
MODE
use the +/- key. The unit for calibration (first unit) is displayed and the
alternate unit (second unit) is blinking.
The key to store the data displayed and proceed to the next step.
The key to proceed to the next step without changing them.
1 and the first unit selected at the previous step. Specify the position of
MODE
dual range
key to select a unit and to select a unit for calibration,
key. Specify the display format (point or comma)
CLEAR
ENTER
key, regardless of what is displayed, the
ESC
Page 13
CLEAR
d Format
d Format d Format
key. The decimal point format
key to store them and proceed to
5.2. Calibration Procedure
key