Exiting The Calibration Mode - AND Weighing Indicator AD-4407 Instruction Manual

Weighing a Mass Weighing a Mass except the Weighing a Mass Weighing a Mass
Step12 Specify a mass value using
Step13 Place a mass equivalent to displayed value
on the weighing unit. Proceed to step 15.
Weighing Capacity Mass
Step14 Place a mass equivalent to the maximum
capacity on the weighing unit.
Step15 Press the
mark turns on. Proceed to step 17.
key .......... The key to proceed to step17
ESC
Caution Do not press the
STABLE mark is off (detecting motion).
Arrange the condition using the F00
filter function.
Digital Input
Step16 Pressing the
parameter of the span is displayed in the
unit of mV/V. Adjust the input voltage
using the
a greater value than the capacity.)
key...... The key to store the span
ENTER
key .......... The key to proceed to step
ESC
5.2.5.

Exiting the Calibration Mode

Step17 Check the
Use the following keys.
key ..... To store the parameters and display
CAL
5.2. Calibration Procedure
except the Maximum Capacity except the except the Maximum Capacity Maximum Capacity Maximum Capacity
0
key after the STABLE
ENTER
without changing the span
parameters.
ENTER
key while the
key, a stored input voltage
+/-
- keys. (It is possible to store
0 9
parameters and proceed to
step 17.
17 without changing the span
parameters.
Calend display.
Caloff . Proceed to the next step.
Caloff could be displayed by pressing
the key while pressing the
+/-
instead of key.
CAL
- keys.
9
key
ON/OFF
Page 16
Span calibration
Maximum capacity
To step 14, step 16
New mass value
Mass of
maximum capacity
To step 14
Place the displayed
To step 16
Turn on STABLE mark
NET/GROSS
Stored input voltage
+/ +/ +/ +/- - - -
mV/V
0
9
mV/V
PRINT
New input voltage
ENTER
or
PRINT
ENTER
Turn display off
AD-4407 Weighing Indicator
To step 12
0
9
step 13
step 14
mass on the
weighing unit
PRINT
ENTER
NET/GROSS
PRINT
+/- - - - +/ ENTER
+/ +/