Fujitsu PRIMERGY 4Gbit/s FC I/O Modules Owner's Manual page 19

12
Check the driver version.
• For 32Bit
5.1.30.9
• For 64Bit
7.1.30.9
13
Close the board property window.
When installation finishes, perform "4.2.2 Installing HBAnyware" ( pg.57).
4.2.2 Installing HBAnyware
1
Insert the driver disk (CD-ROM) into the CD-ROM drive, and
execute "setupapps.exe" in the driver disk.
[CD-ROM drive]: \v1.30a9\AutoPilot Installer\Utilities\setupapps.exe
2
Click [Next].
3
Select "Full Management", check "Allow users to change
management mode from utility.", and click [OK].
4
Click [Finish].
When installation finishes, proceed to "4.3 Checking and Updating Firmware /BootBIOS" ( pg.58).
For details about the uninstallation procedure, refer to "4.4 Uninstalling HBAnyware" ( pg.61).
4 Installing Drivers and Utilities
E
57