4Gbit/S Fc I/O Module To Eternus Connections; Notes On Replacing The 4Gbit/S Fc I/O Module; Points To Note When Using This Driver - Fujitsu PRIMERGY 4Gbit/s FC I/O Modules Owner's Manual

1.4
4Gbit/s FC I/O Module to ETERNUS
Connections
This section explains the connection of the 4Gbit/s FC I/O Module and ETERNUS.
Fabric connection
Connect to the ETERNUS via FC Switch Blade.
BX600 S3 chassis
PRIMERGY BX620 S3/BX620 S4
1.5

Notes on Replacing the 4Gbit/s FC I/O Module

When an operating 4Gbit/s FC I/O Module has been replaced with a new 4Gbit/s FC I/O Module, it
may be necessary to change the storage and FC Switch Blade settings because the WWN of the
4Gbit/s FC I/O Module will change.
1.6

Points to Note When Using This Driver

Event log
When the system is started using this driver, the following logs are stored in the event viewer system
log. They can be ignored.
48
FC Switch Blade (PG-FCS103)
PG-FCD201
FC Switch Blade (PG-FCS103)
ETERNUS3000/
ETERNUS6000