Download Print this page
Fujitsu anywAiR Quick Installation Manual

Fujitsu anywAiR Quick Installation Manual


Quick Links




Summary of Contents for Fujitsu anywAiR

  • Page 2 (d) Power supply + 4 plugs (EU, UK, US, AU) (e) Additional cable * The AnywAiR device requires a (5VDC 0,25 A) NEC Class 2 or Limited Power Source (LPS) and SELV rated powersupply as the one provided. 2. Installation overview The anywAiR device can be installed on a wall mounted position (Figure 2) or in a desktop position (Figure3).
  • Page 3: Device Registration

    • This equipment complies with FCC/IC radiation exposure limits set forth for an • If process is not OK, the anywAiR device LED will be blinking in Red. uncontrolled environment and meets the FCC radio frequency (RF) Exposure Repeat the process from step 1 and check our compatibility list or visit Guidelines in Supplement C to OET65 and RSS-102 of the IC radio frequency
  • Page 4: Warranty

    Pty Limited (ACN 001 229 554) against defects in design, materials and workmanship for a period that term is defined in the ACL, all liability of Fujitsu General (AUST.) Pty Limited for any loss or of 2 years from the date the adaptor was commissioned by Fujitsu General (AUST.) Pty Limited damage, direct and consequential, not covered by this Warranty is expressly excluded.
  • Page 5 FUJITSU GENERAL AUSTRALIA - 1 Telopea Place, Eastern Creek NSW 2766 Ltd ABN 55 001 229 554 - a subsidiari of FUJITSU GENERAL LIMITED Document Review v.1.0...