Drum Maintenance Pivot Plate Assembly - Xerox C2424 - WorkCentre Color Solid Ink Service Manual

Drum Maintenance Pivot Plate Assembly

(PL 2.16)
1.
Remove the drum maintenance kit (page 9-5).
2.
Remove both the right and left side covers (page 8-10).
3.
Remove the paper preheater (page 8-27).
4.
Remove the KL-clip on the left end of the pivot plate shaft.
5.
Remove the grounding clip on the right end of the pivot plate shaft.
6.
Remove the pivot plate shaft.
7.
Disconnect the connector from the I/O Board (connector J860).
8.
Feed the cable into the printer while sliding the drum maintenance pivot plate out
the drum maintenance drawer cavity.
Metal Plate
Note
Lightly grease the metal plates on which the cams ride, using a small
quantity of Rheolube 768 grease (P/N 00679900). Also, fill the pocket under
the shaft ground with grease.
8-36
Metal Plate
2
3
1
Grease Points
Grounding Clip
WorkCentre C2424 Service Manual
s2424-170