Configuring Network Settings For Device Provisioning; Configuring Basic Network Access Settings - Aruba Networks PowerConnect W Clearpass 100 Software Deployment Manual

3.9 deployment guide
Hide thumbs Also See for PowerConnect W Clearpass 100 Software:
Table of Contents

Advertisement

Enter a number in the Maximum Devices field to limit the maximum number of devices that each user may
provision.
Devices are recognized as unique when they have a different MAC address, or a different device identifier
(when the MAC address is not available).

Configuring Network Settings for Device Provisioning

To configure the network settings that will be sent to a provisioned device, go to Onboard > Network
Settings, or click the Network Settings command link. The Network Settings page opens.
This page is used to configure the network settings that will be provisioned to devices.
Note: Some devices do not support all possible combinations of network settings. If you make a selection
that is incompatible with a certain type of device, a message will be displayed in the Onboard user interface.
The Network Access form is divided into several tabs:
Access – Specifies basic network properties, such as the name of the wireless network and the type of
security that is used. See
Protocols – Specifies the 802.1X authentication protocols that are used by the network. See
"Configuring 802.1X Authentication Network
Authentication – Specifies the type of device authentication to be used for the network. See
"Configuring Device Authentication
Trust – Specifies options related to mutual authentication. See
Settings".
Windows – Specifies networking options used only by devices using the Windows operating system.
See
"Configuring Windows-Specific Network
Proxy – Specifies a proxy server to be used by devices connecting to the network. See
Proxy
Post Install – Specifies additional information and instructions to users after the network is
configured. See
Note: Navigating between different tabs will save the changes you have made. The modified settings are
indicated with a "#" marker in the tab. The settings used for device provisioning are not modified until you
click the

Configuring Basic Network Access Settings

Click the
ClearPass Guest 3.9 | Deployment Guide
"Configuring Basic Network Access
Settings".
"Configuring Post-Installation
Save Changes button.
Access tab to display the Network Access form.
Settings".
Settings".
Settings".
Instructions".
Settings".
"Configuring Mutual Authentication
"Configuring
Onboard |
97

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PowerConnect W Clearpass 100 Software and is the answer not in the manual?

This manual is also suitable for:

Clearpass guest 3.9

Table of Contents