Changing Network Security Settings; Resetting The Root Password; Notifications - Aruba Networks PowerConnect W Clearpass 100 Software Deployment Manual

attention. Use the Disable Check link to prevent the security audit from raising warnings about a specific
security condition.

Changing Network Security Settings

Use the Network Security command link to check the current settings for remote console access.
ClearPass Guest has a command line interface(CLI) which may be accessed using the appliance console or
SSH.
Typical usage scenarios where command line access might be used are:
Changing the initial network configuration of the appliance

Resetting the appliance to factory default settings

Resetting a forgotten 'admin' operator login password

Rebooting the appliance

Enabling or disabling remote SSH access

Command line access is not required to perform any normal configuration or management tasks, and
should never be required after the initial setup has been completed.
For this reason, SSH access has been disabled by default. It is recommended to leave this network service
disabled unless you have specific requirements to the contrary.
Network access restrictions for SSH console access may be specified using the Network Login Access
form for operator logins. This can be used to ensure that guests do not have SSH console access, even if it is
enabled for operators; See
control list for operators.

Resetting the Root Password

The root password is required to log into the appliance's console user interface (either directly at the
console, or remotely via SSH). See
The default root password for the appliance is admin.
During the initial setup wizard, the root password is updated to correspond to the administrator's
password.
Once you have set the initial root password, future changes to the administrator password will not change
the appliance's root password.
In order to recover from a forgotten root password, you must have administrative access to the graphical
user interface. Navigate to Administrator > Security Manager, click the Network Security command
link, and then click the
Provide your current operator password, and confirm the new root password by entering it in the
appropriate fields. Click the Set Password button to have the new root password take effect.
The Reset Root Password form is only available to operators with both the Plugin Manager and Network Setup
privileges.

Notifications

Operators with the IT Administrator profile can choose to receive warning notifications by email when disk
space is low. You can configure notification frequency according to remaining disk space, or disable
notifications.
ClearPass Guest 3.9 | Deployment Guide
"Creating a VLAN Interface"
"Console Login"
Reset Root Password link at the bottom of the page.
in this chapter for details on configuring the access
in the Setup Guide chapter for an explanation.
Administrator Tasks | 391