Setting Sequencer - Fujitsu SOFTUNE F2 MC-16 User Manual

2.2.7.1

Setting Sequencer

The sequencer operates in the following order:
(1) The sequencer starts from level 1 simultaneously with the start of program executing.
(2) Depending on the setting at each level, branching to the required level is performed
when the condition is met.
(3) When sequencer termination is specified, the sequencer terminates when the
condition is met.
(4) When the sequencer terminates, the delay counter starts counting.
■ Setting Sequencer
Figure 2.2-6 shows the sequencer operation.
[Use event number 1-]
[Use event number 2-]
[Use event number 3-]
[Use event number 4-]
[Use event number 5-]
[Use event number 6-]
[Use event number 7-]
[Use event number 8-]
Timer condition [Waiting time]
Figure 2.2-6 Operation of Sequencer
Start executing program. (Start sequencer.)
Set Conditions
[Pass counter]
[Pass counter]
[Pass counter]
[Pass counter]
[Pass counter]
[Pass counter]
[Pass counter]
[Pass counter]
Branch to specified level.
CHAPTER 2 DEPENDENCE FUNCTIONS
Operation when Condition Met
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
[Trace control] / [Branch level number]
Terminat
sequencer
Start delay
97