Security; How To Enter - Fujitsu SOFTUNE F2 MC-16 User Manual

CHAPTER 2 DEPENDENCE FUNCTIONS
2.6.1.2

Security

This section describes the security of the MB2100-01 emulator debugger.
■ Security
When beginning to debug it when the security function of target MCU is effective, it is necessary to enter the
password in this emulator debugger.
For the security function, refer to the hardware manual of model to be used.

■ How to enter

When a dialog shown below is displayed, enter a preset password. The password is needs to be entered each
time the debugger is activated.
For details on the password, refer to the description of Password for "OCD (On Chip Debugger)" start
permission in the hardware manual for the product used.
Note:
• When authentification of the password has failed, the debugger cannot be activated. Turn on again
the power supply of the target to activate the debugger again.
• When the user system is in the bus sleep state, press the OK button after the bus sleep state is
canceled.
276
Figure 2.6-2 Debugger Connection Password