Commands Available During Execution Of User Program - Fujitsu SOFTUNE F2 MC-16 User Manual

2.4.3

Commands Available during Execution of User Program

This section explains the commands available during the execution of a user program.
■ Commands Available during Execution of User Program
This emulator debugger allows you to use certain commands during the execution of a user program.
For more details, see "■ Debugger" in "SOFTUNE Workbench Command Reference Manual".
The double circle indicates that it is available during the execution of a user program.
Table 2.4-3 shows the commands available during the execution of a user program.
Table 2.4-3 Commands Available during Execution of User Program
Function
MCU reset
Memory operation (Read/Write)
Line assembly, Disassembly
Notes:
• The conditions which allow you to use the commands in Table 2.4-3 are limited to the following
cases when a user program is executed.
- [Debug] - [Run] - [Go] menu
- [Go] button on the debug toolbar
The commands in Table 2.4-3 cannot be used when the GO command is entered in the command
window.
• An error message appears if you enter a command that cannot be used during the execution of a
user program.
"E4404S Command error (MCU is busy)."
Restrictions
-
Emulation memory only operable
Emulation memory only enabled
CHAPTER 2 DEPENDENCE FUNCTIONS
Major Commands
1.3 RESET
5.1 EXAMINE,
5.2 ENTER,
5.3 SET MEMORY,
5.4 SHOW MEMORY,
5.5 SEARCH MEMORY,
5.8 COMPARE,
5.9 FILL,
5.10 MOVE,
5.11 DUMP
6.1 ASSEMBLE,
6.2 DISASSEMBLE
213