Commands Available During Execution Of User Program - Fujitsu SOFTUNE F2 MC-16 User Manual

CHAPTER 2 DEPENDENCE FUNCTIONS
2.5.3

Commands Available during Execution of User Program

This section explains the commands available during the execution of a user program.
■ Commands Available during Execution of User Program
This emulator debugger allows you to use certain commands during the execution of a user program.
For more details, see "■ Debugger" in "SOFTUNE Workbench Command Reference Manual".
The double circle indicates that it is available during the execution of a user program.
Table 2.5-1 shows the commands available during the execution of a user program.
Besides, when the real-time monitor function is used, the specified memory area will be displayed in the real-
time memory window, and data can be read (updated) even during MCU execution.
Table 2.5-1 Commands Available during Execution of User Program
Function
MCU reset
Displaying MCU execution status
Displaying execution cycle measurement
value (cycle)
Memory operation (Read/Write)
Line assembly, Disassembly
Set breakpoints
*: For further details, refer to Section "2.5.4 Break".
240
Restrictions
-
-
-
-
-
Operable while the "Breakpoint Settings
during Execution" is enabled in the
execution tab of the debug environment
dialog*
Major Commands
1.3 RESET
2.12 SHOW STATUS
4.27 SHOW TIMER
5.1 EXAMINE,
5.2 ENTER,
5.3 SET MEMORY,
5.4 SHOW MEMORY,
5.5 SEARCH MEMORY,
5.8 COMPARE,
5.9 FILL,
5.10 MOVE,
5.11DUMP
6.1 ASSEMBLE,
6.2 DISASSEMBLE
3.1 SET BREAK (type 1),
3.2 SET BREAK (type 2),
3.3 SET BREAK (type 3),
3.6 CANCEL BREAK,
3.7 ENABLE BREAK,
3.8 DISABLE BREAK,
3.9 SET DATABREAK (type 1),
3.10 SET DATABREAK (type 2),
3.12 CANCEL DATABREAK,
3.13 ENABLE DATABREAK,
3.14 DISABLE DATABREAK