Eternusmgr For Windows® Procedure; Setting Items; Target Device Settings - Fujitsu ETERNUS User Manual

Chapter 2 Setup
>

2.3 Setting Items

2
When setting up multiple target devices, copy an existing setup file to make the setup easier. For
details on how to do this, see
2.2.2 ETERNUSmgr for Windows® Procedure
The following describes how to edit a setup file for ETERNUSmgr for Windows®.
The procedure shown is for changing the settings that were set during installation.
Procedure
1
2
2.3 Setting Items
This section explains the setting items (parameters) in the setup files.
2.3.1

Target Device Settings

This section explains the settings that allow ETERNUSmgr to monitor a target device.
Target Address
The target address parameter is used to set the IP address or host name assigned to the target
device.
The target port number does not need to be changed (the default number is normally used).
Target address cannot be omitted. ETERNUSmgr will not start if this parameter has not been
set.
Specify SVP IP address if the ETERNUS6000 is using SVP.
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
Edit the STXPOLL_1.INI file.
Vi editor is used here.
# vi /opt/FJSVgrmgr/STXPOLL_1.INI
"2.5 Monitoring Multiple Target Devices" (page
Confirm the contents of the installation directory using Explorer, etc.
Make sure the following files and folder have been installed in the installation directory:
_stxpoll.ini, STXPOLL.exe, STXPOLL_1.INI, stxpolld.exe, stxsmail.exe, and \www (\www
is a folder).
Edit the STXPOLL_1.INI file.
Edit the STXPOLL_1.INI file using a text editor (Notepad, etc.).
18
34).
End of procedure
End of procedure
Copyright 2009 FUJITSU LIMITED