Events - Fujitsu SOFTUNE F2 MC-16 User Manual

CHAPTER 2 DEPENDENCE FUNCTIONS
2.2.6

Events

The emulator can monitor the MCU bus operation, and generate a trigger at a specified
condition called an event.
In this emulator, event triggers are used in order to determine which function event
triggers are used accounting to event modes for the following functions;
• Sequencer
• Sampling condition for multi-trace
• Measuring point in performance measurement
■ Setting Events
Eight events or less can be set.
Table 2.2-5 shows the conditions that can be set for events.
Table 2.2-5 Conditions for Setting Events
Address
Data
Status
External Probe
Notes:
• In instruction execution, an event trigger is generated only when an instruction is executed. This
status cannot be specified concurrently with other status.
• The data modify is a function to generate the event trigger when the data of a specified address
rewrites. When the data modify is specified for status, the data specification is disregarded. This
status cannot be specified concurrently with other status.
Use the following commands to set an event.
SET EVENT:
SHOW EVENT:
CANCEL EVENT:
ENABLE EVENT:
DISABLE EVENT:
88
Condition
Memory location (Address bit masking enabled)
8-bit data (data bit masking enable)
NOT specified enable
Select from among dada read, data write, instruction execution and data
modify.
8-bit data (bit masking enable)
Sets event
Display event setup status
Deletes event
Enable event
Disable event
Description