Conventions; Information Symbols - Dell FORCE10 Open Automation Configuration

Convention Description
keyword
Keywords are shown in bold and should be entered in the CLI as listed.
parameter
Parameters are shown in italics and require a number or word to be entered in the CLI.
{X} Keywords and parameters within braces are required entries and must be entered in the CLI.
[X] Keywords and parameters within brackets are optional.
x | y Keywords and parameters separated by bar require you to choose one.
Table 1-1. Information Symbols
Symbol Type
Note
FTOS Behavior
Platform-specific
Feature
z
Exception
6 | About this Guide
• S4810 switches require FTOS version 8.3.10.1 or later.
• Z9000 switches require FTOS version 9.0.0.0 or later. (SmartScripts and
SmartUtil support only).

Conventions

This document uses the following conventions to describe command syntax:

Information Symbols

Table 1-1 describes the symbols used in this document.
Description
Informs you about important operational information.
Informs you about an FTOS behavior. These behaviors are inherent to the Dell
Force10 system or FTOS feature and are non-configurable.
Informs you of the platform supporting the Open Automation features.
For example, the S55, S60, and S4810 platforms support all Open Automation
2.0 features. The Z9000 platform supports the SmartScripts and SmartUtil
features.
A note associated with some other text on the page that is marked with an
asterisk.