Dell FORCE10 Open Automation Configuration page 49

Step Task
4
Establish the connection between the
switch and a hypervisor
5
Set the mode for retrieving virtual
server configurations and updating
FTOS settings on the switch.
6
Enable the defined hypervisor
connection.
Command Syntax
access url username username
password password
Where url is one of the following values:
For a VMware hypervisor:
https://[ip-address]/sdk/vimService
username [name] password [password]
For an Xen hypervisor:
http://ip-address username [name]
password [password]
username name: Username to be used for
authentication on the server.
password password: Password to be used for
authentication shown in clear text.
mode {check | config}
check: Retrieve configuration information
from the hypervisor, and notify the system
administrator of any configuration
changes. The configuration changes need
to be entered manually on the switch.
config: Retrieve configuration information
and automatically update the configuration
parameters in FTOS on the switch.
Default: config.
no disable
After you enable VSN on an interface and enable a hypervisor session that connects
to hypervisors on network servers, you can change the
is active. You cannot, however, change the
active. To change these settings, you must:
1. In hypervisor configuration mode, stop the session by entering the
command.
2. Enter the
no type {vmware | xen-citrix}
command to remove a configured setting.
password password
3. Enter the
type {vmware | xen-citrix}
command to configure a new setting.
password
setting when the session
mode
and settings if the session is
type access
or
no access url username username
or
access url username username password
Virtual Server Networking | 49
Command Mode
HYPERVISOR
HYPERVISOR
HYPERVISOR
disable