Dell FORCE10 Open Automation Configuration page 59

hypervisor
Syntax
Parameters
name
Defaults
Command Modes
Command
Version 8.3.8.0
History
Version 8.3.5.1
Version 8.3.3.4
Usage
Information
mode
Syntax
Defaults
Parameters
check
config
Command Modes
Command
Version 8.3.8.0
History
Version 8.3.5.1
Version 8.3.3.4
Specify the name of a hypervisor session with which VSN will connect.
[no] hypervisor name
Enter up to 40 characters to specify the name of a hypervisor session
to which you want to connect on network servers.
None
CONFIGURATION
Introduced on the S4810.
Introduced on the S55.
Introduced on the S60.
After you enter the command, you are placed in hypervisor configuration mode to
configure settings for the session.
Enter the
no hypervisor name
hypervisor session from the running configuration and close active hypervisor
sessions without removing the VSN agent from the system.
Set the hypervisor mode used to retrieve configuration information on virtual servers.
{check | config}
[no] mode
config
VSN retrieves configuration information about virtual servers from a
hypervisor and notifies the system administrator if the configuration
has changed (for example, a VLAN has been added or removed).
Changes in FTOS configuration parameters must be entered
manually on the switch.
VSN retrieves configuration information from the Hypervisor and
implements any necessary configuration changes automatically.
HYPERVISOR
Introduced on the S4810.
Introduced on the S55.
Introduced on the S60.
command to remove the configuration of a specified
Virtual Server Networking CLI | 59