Dell FORCE10 Open Automation Configuration page 54

Command Syntax
show virtualswitch [interface]
[virtualswitch-name]
Command Syntax
show vmmap interface
54 | Virtual Server Networking
To display the components of current hypervisor sessions, including the link, virtual
switch, and hypervisor to which the switch is connected, enter the
virtualswitch command.
Command Mode
EXEC Privilege
Figure 5-5. Display All Hypervisor Sessions: show virtualswitch
FTOS#show virtualswitch
Interface VSwitch
Gi 0/32 vSwitch3
Po 7 vSwitch1
Figure 5-6. Display a Specified Hypervisor Sessions: show virtualswitch
FTOS#show virtualswitch GigabitEthernet 0/32 vSwitch3
Interface :Gi 0/32
Hypervisor Type :vmware
Hypervisor Name :vmware207
Hypervisor Version :4.1.0
Virtual Switch :vSwitch3
Port groups :
Name :VLAN 3
Vlan Id :138
VIFs:
MAC
00:50:56:92:00:77
Name :VM Network 4
Vlan Id :-
VIFs:
MAC
00:0c:29:4f:66:19
PIFs:
MAC
00:26:55:dd:01:4f
To display information on the virtual machines accessed on a switch interface,
including the virtual machine name, VMAC address, and corresponding VLAN ID,
enter the
show vmmap
Command Mode
EXEC Privilege
Task
Display general information on current hypervisor
sessions. To display detailed information on a
hypervisor session, enter the VSN interface and/or
virtual-switch name generated by the hypervisor as
displayed in
show virtualswitch
Hypervisor
VMWare_vmware207
VMWare_vmware206
MTU
8000
MTU
8000
MTU
8000
command.
Task
Display the virtual machines accessed on a switch
interface.
show
output (Figure 5-6).