Dell FORCE10 Open Automation Configuration page 65

show virtualswitch
Syntax
Defaults
Parameters
interface
virtualswitch-name
Command Modes
Command
Version 8.3.8.0
History
Version 8.3.5.1
Version 8.3.3.4
Usage
Information
Example
FTOS#show virtualswitch
Interface
Gi 0/32
Po 7
Display the components of current hypervisor sessions, including the virtual switch
and name of the hypervisor session to which a switch interface is connected,
show virtualswitch [ interface
None
Display information on the hypervisor session established on a
specified interface. Enter one of the following interface types:
•
•
•
Display information on a specified virtual switch by entering the
name generated by the hypervisor.
EXEC Privilege
Introduced on the S4810.
Introduced on the S55.
Introduced on the S60.
Use the show virtualswitch
and hypervisor-session name for all current hypervisor connections on the switch.
To display detailed information on a hypervisor session, re-enter the command with
the interface and virtual-switch name for the session from the
output as shown in the example below.
The following command output displays information on the hypervisor sessions
established on all virtual switches on network servers connected to switch interfaces.
VSwitch
vSwitch3
vSwitch1
] [ virtualswitch-name
For a 100/1000 Ethernet interface or 1-Gigabit Ethernet interface,
enter: GigabitEthernet slot/port
For a 10-Gigabit Ethernet interface, enter:
TenGigabitEthernet slot/port
For a port-channel interface, enter: port-channel number
Where the valid port-channel numbers are 1 to 128.
command to display the interface, virtual-switch name,
Hypervisor
VMWare_vmware207
VMWare_vmware206
]
show virtualswitch
Virtual Server Networking CLI | 65