Dell FORCE10 Open Automation Configuration page 58

access
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
disable
Syntax
Defaults
Command Modes
Command
History
Usage
Information
58 | Virtual Server Networking CLI
Configure the connection to access a hypervisor.
[no] access url username name password password
url
username name
password password
None
HYPERVISOR
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
VSN tries to establish a connection with a hypervisor only after the user credentials
(user name and password) are configured with the
Stop a hypervisor session.
[no] disable
disable
HYPERVISOR
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
Entering the
disable
current hypervisor session. It does not remove connectivity with the hypervisor or
remove the session information from the system configuration.
Enter to re-enable a configured hypervisor session.
no disable
Enter the URL location of the desired hypervisor.
For a VMware hypervisor, enter:
https://[ip-address]/sdk/vimService username [name] password
[password]
For a Xen hypervisor, enter:
http://ip-address username [name] password [password]
Enter the user name to be used for authentication.
Enter the password to be used for authentication in clear text.
command in hypervisor configuration mode disables VSN in the
command.
access