Dell FORCE10 Open Automation Configuration page 68

type
Syntax
Defaults
Parameters
Command Modes
Usage
Information
Command
History
vsn enable
Syntax
Defaults
Command Modes
Command
History
Usage
Information
68 | Virtual Server Networking CLI
Set the hypervisor type to which you want to connect.
{
[no] type vmware
None
vmware
xen-citrix
HYPERVISOR
You must configure a hypervisor type in order to enable VSN connections with
virtual servers. Use the
supported hypervisor types.
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
Enable VSN on an interface.
[no] vsn enable
VSN is disabled by default on switch interfaces.
INTERFACE
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
Enter the
vsn enable
this command on an interface used for inter-switch links.
Enter the
no vsn enable
You must reconfigure VSN to re-enable a hypervisor session.
| }
xen-citrix
Set the hypervisor type as VMware.
Set the hypervisor type as Xen-Citrix.
show hypervisor supported
command only on hypervisor-facing interfaces. DO NOT enter
command to remove the VSN configuration from the system.
command to display the currently