Dell FORCE10 Open Automation Configuration page 60

Usage
Information
package install
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
60 | Virtual Server Networking CLI
You can use the
information is retrieved in an existing hypervisor session.
The following log messages are displayed when the hypervisor mode
retrieve configuration information on virtual servers:
Message 1
Dec 1 04:57:48: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_DISCOVERY: Te 0/35, Vlan:
4001-4008,4011-4012
Message 2
Dec 1 04:56:46: %STKUNIT0-M:CP %VSNMGR-5-VSN_VLAN_WITHDRAWAL: Te 0/35, Vlan:
4001-4008,4011-4012
Install an Open Automation package, such as Virtual Server Networking. This
command downloads the package from the specified location, and installs it in the
internal flash memory on a switch.
package install location
location
None
EXEC Privilege
Version 8.3.8.0 Introduced on the S4810.
Version 8.3.5.1 Introduced on the S55.
Version 8.3.3.4 Introduced on the S60.
Because the installation of the VSN package takes time, the installation is performed
in the background. When the download is complete, a message is displayed on the
console.
To follow the progress of a package installation, enter the
command to change the way in which virtual-server
mode
Enter the location where you want to install an Open Automation
package, where location is one of the following values:
• flash://filename installs the VSN package file stored in flash
memory on the switch.
• ftp://userid:password@host-ip-address/file-path logs in and
installs VSN from a file stored on an FTP server.
• tftp://host-ip-address/file-path installs VSN from a file stored on
a TFTP server.
is used to
check
show packages command.