Table of Contents
Advertisement
Rules for Using Commands
Use each command according to the following rules.
• Prefix all commands with "#", and specify the #Password command at the top of the
e-mail.
• Command lines without "#" are ignored.
• Write one command on each line and separate each command and parameter with a
space or a tab.
• When the same command is written two or more times in one e-mail, the second and
subsequent commands are ignored.
Example of Commands
1.
When the read only password is "ronly", and to check the printer status.
#Password
#Status
2.
When the full access password is "admin", and to set the recipient e-mail address to
"service@fujixerox.co.jp".
#Password
#SetMsgAddr
3.
When the full access password is "admin", and to set the recipient e-mail address to
"service@fujixerox.co.jp", then confirm the setting result on the network settings list.
#Password
#SetMsgAddr
#NetworkInfo
Note
• Describe the "#SetMsgAddr" command before the "#NetworkInfo" command. If they are written in
reverse, the information retrieved by the "#NetworkInfo" command and the result of executing the
"#SetMsgAddr" command may differ.
ronly
admin
service@fujixerox.co.jp
admin
service@fujixerox.co.jp
6.5 Checking Printer Status via E-mail
95
Advertisement
Table of Contents
Troubleshooting
