Description Of Menu Items; Tray Settings - Xerox DocuPrint C2535 A User Manual

4.2

Description of Menu Items

This section describes the items that can be configured on each menu.

Tray Settings

Use the Tray Settings menu to define the paper size and type loaded in each tray.
Item
Display Popup
Bypass Mode
Paper Type
Paper Size
Note
• When the size or type of paper that is loaded is different from the setting, the print quality may fall or
paper may jam. Specify the correct paper type and size.
• When installing the optional sheet feeders if [Paper Source] is set to [Auto] on the print driver, the
feeding tray is automatically specified according to the setting on the control panel. Also, when installing
two optional sheet feeders and the paper size and type setting for each tray is the same, printing
continues by changing the feeding tray if the paper in the specified tray has run out.
48
4 Setting on the Control Panel
Specifies whether to display the message that prompts you to set the paper size and
type or not every time you load paper to the bypass tray or 550 Sheet Feeder (optional).
When you select [On], the message that prompts you to set the paper size and type is
displayed.
• [Bypass Tray] (default: [Off])
• [Paper Tray] (default: [Off])
Specifies the way to set the paper type and size settings to be loaded in the bypass tray.
• [Panel Specified]
You can specify the paper type and size settings on the control panel. Printing can be
done only when the settings on the print driver matches the settings on the control
panel. When a mismatch of paper sizes occurs, follow the instructions displayed on
the control panel.
• [DriverSpecified] (default)
You cannot specify the settings on the control panel. Printing is done using the
settings on the print driver.
Specifies the type of paper loaded in each tray.
• [Tray 1] (default: [Plain])
• [Tray 2] (default: [Plain])
• [Tray 3] (default: [Plain]
• [Tray 4] (default: [Plain])
• [Bypass Tray] (default: [Plain])
Note
• [Tray 2], [Tray 3], and [Tray 4] are displayed only when the optional sheet feeder is
installed.
• [Bypass Tray] is displayed only when the [Bypass Mode] is set to [Panel Specified].
Refer to
• "Setting Paper Types" (P. 44)
Specify the paper size and orientation for the bypass tray. This item is displayed when
the [Bypass Mode] is set to [Panel Specified].
• [Bypass Tray] (default: [Driver Size])
Refer to
• "Setting Paper Sizes" (P. 44)
Description