Setting The Protocols - Xerox DocuPrint C1618 User Manual

1.2 Configuring the Printer
1.2.4

Setting the Protocols

When the printer is shipped from the factory, all protocols except SMTP/POP3 ("Status Messenger",
"E-Mail Printing") and "FTP" are "Enabled" by default. You do not need to perform the operations
described in this section when you connect a new printer to a network for the first time.
This concludes the Printer Settings list. Move on to "1.2.5 Checking Settings".
1
When you want to use the printer as a network printer, you need to set the right
protocols on the printer.
q For TCP/IP(LPD)
q For Port 9100
For IPP
q
q For SMB (transport protocol: TCP/IP)
For SMB (transport protocol: NetBEUI) →
q
q For NetWare
Follow the procedure below.
When you want the printer to send and receive e-mail, start the "Status Messenger" and "E-Mail
Printing" protocol in the same way.
The procedure is described using screen examples with the optional network expansion card installed.
If you do not have an optional network expansion card, the following protocols do not appear:
q SMB TCP/IP
q SMB NetBEUI
q NetWare
Refer to "5.2 Basic Menu Operation" and "Appendix B Control Panel Menu List" for information
about the operation of the control panel.
16
→
"LPD" protocol
→
"Port9100" protocol
→
"IPP" protocol
→
"SMB TCP/IP protocol
"
"SMB NetBEUI" protocol
→
"NetWare protocol
"