Table of Contents
Advertisement
About available paper for 2 sided print
Paper of 60 to 105 g/m
2
of 106 gm
or more for a 2 sided print, the range of printed text on the reverse
side may be out of alignment. It is recommended to use Tray 5 (bypass tray) to
manually print both sides of the paper if you print paper of 106 g/m
F.2
TCP/IP (1pd)
The precautions/limitations of using TCP/IP (LPD) are as follows:
Configuring the machine
●
Pay close attention when setting the IP address. The IP address is the address
maintained over the system. Consult your network administrator before
defining any address.
●
Depending on the network environment used, it may be necessary to set the
subnet mask and gateway. Consult your network administrator before defining
the needed item.
●
If setting the port to [Enable] leads to insufficient memory, the port status may
be set to [Disable] automatically. In this case, either set the port to [Disable]
when it is not used or change the memory allocation capacity.
Specify the size for the receiving buffer memory [LPD Spool] as required by the
●
environment in use. If the size of the receiving buffer memory [LPD Spool] is
smaller than the transmitted data, the data may not be received.
Configuration of the computer
●
Pay close attention when setting the IP address. IP address is the address
maintained over the system. Consult your network administrator before
defining any address.
●
Consult the Network Information Service (NIS) administrator when setting the
network (such as the IP address) by a host being used under NIS.
2
can be used for 2 sided print. However, if you use paper
F Precautions/Limitations
2
or more.
267
Advertisement
Table of Contents
Troubleshooting
