4.2
Loading Paper
4.2.1
Loading paper into Trays 1 to 4
This section describes how to load paper into Trays 1 to 4. The same steps are
applied when changing the paper size in Trays 1 to 4.
When a paper tray runs out of paper during printing, a message will appear on the control panel
●
display. After feeding the paper, printing will be automatically restarted.
For information about printing non-standard paper size, refer to "3.3 Printing Non-Standard/
●
Long Paper Sizes" (P.65).
Procedure
1
Pull out the paper tray until it no longer
comes out.
2
Adjust the head of the paper guide to
the desired paper size scale by using
the two clips on the paper guide (1, 2).
Check that the paper guide is properly fixed into the
●
hole at the scale. If the paper guide is not adjusted to
the size scale, the paper size may not be automatically
detected. If so, move the paper guide and then adjust
it to the scale again.
Be sure to set the three directional paper guides to
●
the paper size scale. Do not load paper that has a
width that is smaller than that to which the guides can
be set. The printer may be damaged if they are not set
correctly.
■For Tray 1
■For Trays 2 to 4
4
117