Xerox DocuPrint C2428 User Manual page 246

7.8 Adjusting Gradation
(16)To adjust other
colors, press the
<
several times
until the display
returns to
[Photo] and
repeat steps
(11) to (15).
7
To check the adjustment result, refer to "Printing Chart" (P.238) and print the
appropriate chart.
If you cannot get a satisfactory result, do the adjustment again.
[Process Gray] is gray obtained from a combination of C, M, and Y. If adjustment is
correctly performed, this gray will become colorless gray like black. If you feel that any
color of C, M, and Y in Process Gray is stronger than others, adjust that color again.
246
Continued from the previous page
Photo
Enter Value
(10)Press the <
Photo
Cyan
(11)Press the <
Photo
Cyan
(12)Press the <
Cyan Photo
L= 0,M= 0,H= 0 *
(13)Press the <
Cyan Photo
L= 0,M= 0,H= 0 *
> button
(14)Press the <
Cyan Photo
L= 0,M= 1,H= 0
(15)Press the <Eject/Set> button.
Cyan Photo
L= 0,M= 1,H= 0 *
(17)Press the <Menu> button after adjustment of desired
Ready to print
> button.
(Photo is displayed.)
> or < > button to select desired color.
> button.
> button to select desired density
(L-Low Density, M-Middle Density, H-High Density).
(Underline appears below the selected value. "*" is
displayed at the right edge until you change the
value.)
> or < > button to enter the value of
[Adjustment Value] on the computation table of the
chart.
(Density adjustment value is
determined.)
color is finished.
(Returns to Power ON status. Data
receiving enabled.)