Xerox DocuPrint C3055 User Manual page 151

Message
Open Tray N
Clear Jam
then
Open & Close A
(N: tray 1 - 4)
Out of memory
Press SET
Out of Toner [X]
Replace Toner
(X: K, C, M, or Y)
Paper different
from Setting.
Open Tray 1 & A
Clear Jam
PDL Error
Press SET
Print memory
full. Press SET
Push in Tray N
(N: tray 1 - 4)
Push in trays
Push in
all trays
Ready to print
Drum Cartridge
Ready to print
Replace soon
Ready to print
Fuser Unit
Ready to print
Replace soon
Ready to print
Non-Genuine
A paper jam occurred in the printer.
Pull out the tray N to identify the jammed area, and remove the jammed paper. Then,
push up the lever A and open and close the front cover. Open the front cover even
when there is no jammed paper inside the cover. The error will not clear unless you
open and close the front cover.
Refer to
• "6.1 Clearing Paper Jams" (P. 132)
The job cannot be printed due to insufficient memory.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Reduce the number of files to print and try printing again. If the same message keeps
appearing, we suggest you to install additional memory.
The X toner cartridge has run out of toner.
Replace the X toner cartridge.
Refer to
• "Replacing the Toner Cartridges" (P. 164)
A paper jam occurred since the paper type requested by the job does not match the
paper type setting of the tray 1.
Pull out the tray 1 or open the front cover by pressing the lever A and find the
jammed area. If you see the jammed paper, remove it from either location, whichever
is easier.
Then, check the paper type settings on the print driver and the printer.
Refer to
• "6.1 Clearing Paper Jams" (P. 132)
• "[Paper Type]" (P. 121)
An error occurred while processing the job.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Check if there is any problem with the print data.
The job was not printed due to insufficient memory.
Cancel the job by pressing the <Eject/Set> button on the control panel.
Reduce the number of files to be printed. If the message keeps appearing, we
suggest you to install additional memory.
The tray N is open.
Push the tray firmly into the printer.
The printer was requested by the job to automatically select a paper tray, but all
paper trays are open.
Push the trays firmly into the printer.
The job requested a paper tray, but one of the trays above it is open.
Close the open tray.
The drum cartridge needs to be replaced soon. Have a new cartridge ready.
The fuser unit needs to be replaced soon. Have a new fuser unit ready.
The printer is set to the [Non Genuine] mode. The Non Genuine mode does not
ensure print quality and may not provide the best performance. This mode can also
cause printer malfunction. Use only the toner cartridges that are recommended.
Refer to
• "Non-genuine Mode" (P. 160)
Symptom/Cause/Remedy
6.6 Error Messages and Error Codes
151