Ribbon Errors; Resolving The Skipping Ribbon Panel Issues - Fargo Persona M110 User Manual

RESTRICTED USE ONLY

Ribbon Errors

Resolving the Skipping Ribbon Panel issues

Symptom: The Printer is using more than one set of ribbon panels to print one side of a
card.
Step Procedure
1 Calibrate the Ribbon Sensor. (See the next page for illustration.)
a. Reset the Printer to clear any Error Messages by removing Power and
reapplying.
b. Open the Printer Control Panel from the Computer.

If using Windows 95/98/ME, right click on the C11 Card Printer Icon
and select Properties.

If using Windows NT 4.0, right click on the C11 Card Printer and
select Document Defaults.

If using Windows 2000/XP, right click on the C11 Card Printer and
select Printing Preferences. Click on the Calibrate tab.
c. Click on the Sensors button. (See the next page.)
d. Remove the ribbon and close the top cover.
e. Click on the Send button for a ribbon Sensor calibration.
f. Verify that the Printer beeps twice.
g. If the Printer does not beep twice, see Communications Errors in Section
2, Page 30.
Persona C11 Card Printer and Persona M11 Card Printer User Guide (Rev. 5.0)
Fargo Electronics, Inc.
Continued on the next page
40