Toshiba e-STUDIO4500c Service Manual page 8

2.2.3 INSTALLATION, DISASSEMBLY, AND ADJUSTMENTS
CAUTION
1. After installation, maintenance, or adjustment, always check the operation of
the machine to make sure that it is operating normally. This ensures that all
shipping materials, protective materials, wires and tags, metal brackets, etc.,
removed for installation, have been removed and that no tools remain inside
the machine. This also ensures that all release interlock switches have been
restored to normal operation.
2. Never use your fingers to check moving parts causing spurious noise. Never
use your fingers to lubricate moving parts while the machine is operating.
3. When the parts are disassembled, reassembly is the reverse of disassembly
unless otherwise noted in this manual or other related documents. Be careful
not to install small parts such as screws, washers, pins, E-rings, star washers
in the wrong places.
4. Basically, the equipment should not be operated with any parts removed or
disassembled.
5. Return the equipment to the original state and check the operation when the
service is finished.
6. Be careful when removing the covers since there might be the parts with very
sharp edges underneath.
2.2.4 SPECIAL TOOLS
CAUTION
1. Use only standard tools approved for machine maintenance.
2. For special adjustments, use only the special tools and lubricants described
in the service manual. Using tools incorrectly, or using tools that could
damage parts, could damage the machine or cause injuries.
- 6 -