Toshiba e-STUDIO4500c Service Manual page 475

April, 2007
6. Change the Fusing Temperature settings according to the type of "Middle
Thickness Paper Mode", which is most appropriate for the poor fusing symptom.
1) "Middle Thickness Paper Mode -1" (Default)
NOTE: This setting is effective both for poor fusing and the sponge image /
stripper streaks. You do NOT have to change any SP settings (Default
settings are OK).
SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Default: 180.
SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Default: 180.
2) "Middle Thickness Paper Mode -2"
NOTE: This setting should be selected if the effectiveness of "Middle
Thickness Paper Mode-1" is not enough for the poor fusing. However,
with this setting, it is easier for stripper streaks to occur.
Change the following SP setting as a set.
SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Change to 185 (default: 180)
SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Change to 185 (default: 180)
3) "Middle Thickness Paper Mode -3"
NOTE: This setting should be selected if the effectiveness of "Middle
Thickness Paper Mode-2" is still not enough for the poor fusing.
However, with this setting, it is easier for stripper streaks to occur.
Change the following SP setting as a set.
SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Change to 190 (default: 180)
SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM)
Change to 190 (default: 180)
SP1107-001 (Mode Shift Low Temp SW)
Change to 0 (default: 5)
ADDITIONAL INFORMATIONS
4-97