Toshiba e-STUDIO4500c Service Manual page 679

August, 2006
9407 Environ Cntrl
001 Environ Cntrl
004 Op Humidity
005 Stop Humidity
006 Op On Time
007 Op Off Time
IMPOTANT:
As a general rule, keep this SP mode disabled.
Enable this SP mode ONLY WHEN:
1. The temperature in the room is low, and
2. There is condensation on the drum or charge roller, and
3. The images on the printouts are blurry
To enable the Peltier unit:
1. Set this SP mode to a value of 1, and
2. Turn OFF the AOF function in User Program Mode.
NOTE: There are some environmental conditions that the Peltier unit needs to
operate (ex: humidity of 60% or higher). If the Peltier unit does not
operate after you do the above steps, it is because these conditions are
not satisfied.
When the AOF function is turned OFF, the machine is not in compliance with the
Energy Star requirements.
Enable/disables the Peltier unit.
[0 to 1 / 1]
0: Disabled
1: Enabled
Factory Use Only. Do Not Touch in the field.
Factory Use Only. Do Not Touch in the field.
Factory Use Only. Do Not Touch in the field.
Factory Use Only. Do Not Touch in the field.
5-187
SERVICE PROGRAM TABLES