Toshiba e-STUDIO4500c Service Manual page 521

April, 2007
1110 Paper Type Selet
These SP settings switch the ON/OFF the paper type type detection and double-
feed functions.
[0~1/1]
0: Enable
1: Disable
Two sensors, one mounted above and one below the paper at the registration
rollers, detect the opacity of the first sheet and compares this reading for every
subsequent sheet. If the reading is higher (thicker paper) or lower (thinner paper)
the sensor triggers an error.
Paper Type
001 Tray 1
002 Tray 2
003 Tray 3
004 Tray 4
005 Bypass
006 LCT
Double-Feed
007 Tray 1
008 Tray 2
009 Tray 3
010 Tray 4
011 Bypass
002 LCT
1111 Nip Width Mode
001 Execute
002 Stop Time
003 Stop Interval
1112 Fuser Unit In/Out
Determines whether the fusing unit operates during the copy cycle for image
creation and paper feed.
0:OFF, 1:ON
Paper Type Select
Japan Only
Japan Only
Nip Width Measurement Setting Mode
Determines whether the nip at the hot roller and pressure
roller is calibrated. Press [Execute].
Determines the down time of the fusing/exit motor in the
fusing nip band calibration mode.
[1~100/1 sec.]
Determines the intervals between the down times of the
fusing/exit motor in the nip band calibration mode.
[0~2000/100 msec.]
Fusing Unit: In/Out – Start Fusing Unit
5-29
SERVICE PROGRAM TABLES