Toshiba e-STUDIO4500c Service Manual page 545

April, 2007
2426 LEdgeCor:Norm FC
This SP sets the coefficient used to 1) correct bias at the leading edge for full-color
image transfer (ITB) bias at image to paper transfer when using plain paper, and 3)
correct the dc and ac voltages applied at paper separation.
Notes: These settings apply:
Only the distance from the leading edge set with SP2427.
Only to full color printing on plain paper at full speed.
001
ITB
007
Side1:PTR
008
Side1:SepDC
009
Side1:SepAC
012
Side2:PTR
013
Side2:SepDC
014
Side2:SepAC
2427 LEdgeSWT:Norm FC
This SP sets switch timing that sets the distance from the leading edge where the
settings of SP2426 001 are to apply. The value selected is the number of mm from
the leading edge of the paper. These settings 1) apply only full-color printing on
plain paper at full speed, and 2) apply to to both sides of a duplex page.
001 ITB
002 PTR
003 SepDC
004 SepAC
2428 TEdgeCor:Norm FC
This SP sets the coefficient used to correct bias at image to paper transfer for each
side of the paper. These settings are applied to the trailing edge for full-color
printing on plain paper at full speed as far as where SP2429 002 takes effect.
007 Side1:PTR
012 Side2:PTR
2429 TEdgeSWT:Norm FC – PTR
002 This setting sets the start timing for application of SP2428 007, 2428 012 at the
trailing edge of each sheet (Side 1, Side 2). These settings are applied to the
trailing edge for black printing on plain paper at full speed and apply to black, even
when printing in full color mode.
[-100~0/1 mm]
The "mm" distance is measured away from the trailing edge of the image.
Leading Edge Correction for Plain Paper: FC
[0~400/1%]
[0~400/1%]
[0~400/1%]
[0~400/1%]
[0~400/1%]
[0~400/1%]
[0~400/1%]
Leading Edge Switch Timing for Plain Paper: FC
[0~30/1 mm]
[0~30/1 mm]
[0~30/1 mm]
[0~30/1 mm]
Trailing Edge Correction for Plain Paper: FC
[0~400/1%]
Switch Timing for Plain Paper: FC
5-53
SERVICE PROGRAM TABLES