Removing The Broil Burner & Ignitor - Whirlpool SF372BEE W/N Service Manual

REMOVING THE BROIL BURNER & IGNITOR
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
1. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
2. Remove the oven door (see page 1-20 for the
procedure).
3. Remove the oven racks.
4. Remove the four heat shield screws and the
front broil burner screw.
FRONT BROIL
BURNER SCREW
HEAT SHIELD
5. Remove the clip holding the ignitor wires to
the rear oven liner.
BROIL BURNER
BROIL IGNITOR
BACK OF
OVEN LINER
CLIP
QUICK–DISCONNECT PLUGS
(LOCATED BEHIND RANGE)
6. Remove the broil burner and ignitor assembly
screws, and pull the quick-disconnect plugs
for the ignitor through the hole at the rear of
the oven liner.
7. Disconnect the broil ignitor quick-disconnect
plug from the main harness plug.
8. Remove the broil ignitor from the broil burner
bracket.
9. Mount the new broil ignitor to the new broil
burner.
10. Mount the broil burner and ignitor assembly to
the oven.
11. Reassemble the range.
3-24
MOUNTING BRACKET
MOUNTING SCREWS