Whirlpool SF372BEE W/N Service Manual page 52

REMOVING THE IGNITOR MODULE & A BURNER IGNITOR
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electri-
cal shock.
CAUTION: When you work on the gas range, be
careful when handling the sheet metal parts. Sharp
edges may be present, and you can cut yourself if
you are not careful.
REMOVING THE IGNITOR MODULE
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
3. From behind the range, remove the upper
access cover.
4. Disconnect the wires from the old ignitor mod-
ule (see the inset on the next page).
5. Remove the old ignitor module from the upper
console and mount the new one in its place.
6. Connect the burner ignitor wires to the ignitor
module terminals.
7. Reassemble the range.
REMOVING A BURNER IGNITOR
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the gas to the range and disconnect
the power cord from the wall outlet.
3. Remove the grates from the maintop.
Conventional Burner Models
4. Lift the maintop until the support rods lock.
5. Remove the screw from the burner ignitor
ground strap and unhook the strap from the
burner bracket.
TAB
6. Remove the ground strap from the old burner
ignitor and snap the new ignitor into it.
7. Mount the burner ignitor and ground strap to
the burner bracket with its mounting screw.
8. From behind the range, remove the upper
access cover.
9. Locate and disconnect the old burner ignitor
wire from the ignitor module.
10. Route the wire from the new burner ignitor,
through the upper console to the ignitor mod-
ule, and connect it to the terminal.
11. Reassemble the range.
3-10
GROUND STRAP
SNAP IGNITOR
INTO SLOTS
SCREW
BURNER IGNITOR
BURNER
BRACKET