Pull the range away from the wall so that you
can access the back.
From behind the range, remove the upper and
lower access covers and the lower heat shield.
Unplug the burner ignitor wires from the igni-
tor module, pull them through the back of the
upper console to the front, and remove them
from the maintop.
Cooking Products Service Manual
© 1996 Whirlpool Corporation
Slide the maintop to the right so that the left
hinge pin is free of the hinge bracket, (see the
inset), and then to the left so that the right
hinge pin is free of its bracket, then set the
maintop with the burner ignitors on top of the
range. CAUTION: Be careful not to pull on
the spark ignitor wires or you will pull them
out of the ignitors.
10. Remove the hinge pins from the old maintop
and install them on the new one.
11. Install the new maintop and burner ignitors
and reassemble the range.
PIN IN BRACKET
HOLE IN UPPER